Product Care Guide

Product Care Guide

For newly applied or installed Pool Coating, Concrete Texture Coatings or specialty coatings.

Care for your new aquatic surface

Outdoor pools and whirlpools can be filled immediately upon adequate cure usually 3-12 hours.
Indoor pools should use air movement for several days prior to filling and air movement as the pool is filling. Replace filter sand after 12-24 hours of circulation. As a minimum replace the top 4"- 6" of filter sand.
Maintain an adequate water level in the swimming pool or whirlpool at all times as a condition of the 25 year warranty.
Temporary staining can be removed with a non abrasive pad and any commercially available pool cleaning solvent.
Maintain proper water balance at all times, in accordance with Fibre Tech's care and use guide.

Care for your new concrete texture coatings

Clean foot traffic is allowed in 8 hours.
Unlimited foot traffic is allowed in 24 hours.
Car, bicycle, motocycle, skateboard and inline skate traffic allowed in 7-10 days.
Displaced patio furniture can be replaced in 7-10 days.
Remove debris as needed with a broom, blower, vacuum, hose or pressure washer. When pressure washing do not exceed 1000psi.
Clean with Simple Green or a mild detergent with a soft bristle brush and warm water.
Do not use solvent based cleaners.
Remove snow with a plastic shovel or a metal shovel with no sharp or worn edges.
If a snow blower must be used, raise the blade 1/4" by lowering the shoes 1/4". Make sure your shoes are not rusty or having sharp edges. Replacement shoes are readily available.
Never use a snow plow.
Reseal as needed. General reseal guidelines: Typically only one coat is required with minimum prep. Driveways 2-3 years, garage floors 3-5 years, patios and sidewalks 5-7 years, indoor applications 5-7 years. Your warranty is renewable with timely reseals as determined by us.

For further assistance regarding the care of your application call 715-340-9587
or email questions by clicking the logo below